I can't get my nolva to mix. I have heated it, but it seems that the powder just falls to to bottom. Is there something else I should do?
I can't get my nolva to mix. I have heated it, but it seems that the powder just falls to to bottom. Is there something else I should do?
What are you using to suspend it in and what concentration are you trying to make?
I got it from PNP
Mine does the same thing. When it does I usually heat it and then shake it. I think thats the best thing to do before you take it.
That what I have been doing. It jsut doesn't seem like your getting an accurate dose.
What size pin are you using?
I hope you aren't injecting it.
no he isn't, he's just trying to draw those flakes up. heat it longer and at a slightly higher temperature.
I'd send them an e-mail and complain.Your paying good money for a finished product that isn't supposed to crash.
i quit buying liquid nolv and started ordering genox (generic tamoxifan) through a canadian pharmacy for dirt cheap..... canucks good for something i guess
i mix my own with everclear,it does fall out on occasion but i heat in a pan of water,bring close to a boil and shake and it is completely disolved again.
I have the same sh*t from pnp, white flakes all over the place. I sent an email yesterday, i will wait for a reply.. but if you have to heat it everyday isn't that at the least a little inconvienent?
i suggest trying to get your money back or something....It sounds like the concentrations they are trying to make are too high for the solvent they are using.
i would go with assymetrical1's idea next time. I have ordered cynomel from international pharms. and it came through fine..
There are currently 1 users browsing this thread. (0 members and 1 guests)