OK, so the other day I was going to inject some sust.
I like to do the following when breaking open the amps
- I hold the amp in my right fist.
- I wrap my left hand around my right hand (almost looks like I`m praying)
- Then I use a thumb to press at the top of the amp. If it doesn`t snap when "correct" use of force is applied, I rotate it to find the weakness in the glass.
As you know the glass is supposed to be a bit weak right in the bottleneck, on one side, so that it can be snapped open.
Well, I did my procedure and lo and behold, the whole thing imploded on me.
Turns out that the weakness in the glass stretched all the way down one side of the amp, from top to bottom. This resulted in me driving my thumb through the amp and getting juice and broken glass all over my hands.
I picked up another amp, and did the excact same thing. This time it went flawlessly.
I did another couple of injections as time went by, and yesterday it almost happened again. Only this time, the "ring" area where the amp is supposed to break remained intact and instead only the top centimeter of the the amp disintegrated. It resulted in cursing and some minor bleeding, but I was able to inject the juice.
Have any of you guys experienced this poor quality in the glass of the manufactorer?
My source has been de****g roids for at least 22 years (he got busted by the cops in the early 80s) and I`ve known him for years, so he`s got legit sources and isn`t screwing me over. That makes it all the more strange.