aspirate

[stunner5000pt]

This is a hypothetical question, i am not currently on anything and dont plan to do anything until maybe 2 years from now.

What if one were to forget to aspirate while injecting an oil based steroid??
best case scenario is that you didnt inject into a vein and you'll be fine

what about the worst case scenario? THat is if you inject into a vein? Do you have the heart attack (is that youll get?) immediately after? Is there enough time to react?

[stunner5000pt]

bump

too soon for a bump??

[MasterShake]

I can't say what the worst case would be,
but why worry about it? Just asperate.
Then you will be safe from whatever the
worst case might be.

[ToTheBuckeT21]

I think it depends what it is ur injecting and how much u are injecting.. i think like 1ml might be kinda painful.. 3ml might be problems.. when i inject i put the pin in all the way and as i inject i slowely.. very very very slowely sort of take it out.. so when i start there is 1.5 inches of pin in and when i'm done there is only 1 inch.. this way even if i did hit a vein and didn't notice it when i aspriated for whatever reason i wont be injecting a large amount into the one vein..

[cornhole]

bucket a better way to inject would be to z track and keep the needle sunk in deep while injecting,and when finished injecting pull the needle out half way and stop for about 10 seconds,then pull the rest of the way out.this allows the blood to start coagulating and clot so no gear leaks out.

[ToTheBuckeT21]

word.. u pretty smart newbie

[fhorst]

it depends on what you inject.
If you inject 1.5 ml Tren100 in a vain, say good night.
If you inject test it will feel bad, but you live.

Best is to inject slowly. If you are injecting in a vain, you feel it within seconds.

and like the bro's said, better to aspirate.