Couldnt find old thread: heating gear

[sircharles]

I couldnt find the old post that answered my questions, sorry

Im gonna be using Whiteys Homebrew to convert powder-to injectable gear.

One of the steps is 'heating' the horomone/ba bb mixture. It says hot bath water or stove water.

Im gonna opt to use the stove set on low (hot but not near enough to boil). How long do I leave the cylinder sitting in the water before I stir/repeat?

[shifty_git]

this should be posted in the lab forum fella.

.....but should be about 10min, keep heating untill it goes nicely clear

[one8nine]

just stir keep stiring it in there until you cant see powder anymore. it really depends, just keep heating and stiring until you dont need to anymore.

keep in mind that oil has a much higher boiling point than oil

ps i put mine on high and stir until its in solution. it ends up boiling.

[sircharles]

just stir keep stiring it in there until you cant see powder anymore. it really depends, just keep heating and stiring until you dont need to anymore.

keep in mind that oil has a much higher boiling point than oil

ps i put mine on high and stir until its in solution. it ends up boiling.

Oil has a higher boiling point than oil? Little confused.

ps: thanx for the help guys

[shifty_git]

oil has a higher boiling point than water....