ED Shots

[ramacher]

Was thinking if I used a 29 gauge or 31 gauge slin pin to pin ED where would the best spots be. 29 gauge is 1 inch needle and 31 gauge is 5/8 inch. Has anyone done gear with slin pins anyway? My only worry is I don't actually hit the muscle. My previous cycle my roommate down the hall was going to be a doctor, so she did all the injections. So this is new to me.

Thanks,

[baseline_9]

You could use those 29g 1inch anywhere really unless ur really fat

Using slin pins is just gonna cost u a load in the long run tho

[ramacher]

if somehow I don't hit a muscle does sub-q have any negative impacts? My thinking if you hit it sub-q where there is more fat = slower absorption rate, but if i hit my delts where there is not as much fat, does it hit my body quicker as well?

[Dr Pepper]

What compound are you using?

[ramacher]

I would be using test prop and masteron ED around the same time at night. Also thinking of adding tren but not sure yet.

[Dr Pepper]

Have u used slin pins before for prop? I don't know if you will be able to push the oil through at 29g... My 2c

[ramacher]

actually it is easier to push oil through a 31 gauge than a 29 believe it or not. Don't know why, but it probably has to do with the 31 gauge being smaller circumference and more pressure. I tried both.

[Black]

I'm curious what people who use slin pins do when they need to inject more than 1cc. Do you do multiple injections?

[stpete]

I'm curious as to why people can't inject the correct way. AAS is supposed to be used IM. Do it right and you have nothing to worry about.
Use 23 or 25ga 1" or 1.5"
OP-What were your previous cycles?

[Pac Man]

I use 27g 1.5" for ed inj. 29 or 31 would be retardedly slow. Too impatient for all that.

[songdog]

I agree just do it the way you are suppose to.And using masteron at your bf would be a waste.You need real low bf to see results.Also I see this will be your 2nd cycle.I would lay off the tren also.Hit the diet section and learn how to eat.Try prop and Var.

[dec11]

just use standard pins mate. you do know ed pinning is completely unnecessary? i was pinning my tren 50mg ed and was getting a boat load of sides, i switched to 100mg eod and bingo, sides dropped!!

[ramacher]

ok thanks dec! But when I am pinning what if I don't actually hit the muscle, and instead go sub-q for whatever reason?

[dec11]

ok thanks dec! But when I am pinning what if I don't actually hit the muscle, and instead go sub-q for whatever reason?

it will still get in the system maybe just alittle slower. kinda hard to miss muscle with a 1" needle mate unless you're a whale. 1.5" for glutes of course

[gixxerboy1]

I'm curious as to why people can't inject the correct way. AAS is supposed to be used IM. Do it right and you have nothing to worry about.
Use 23 or 25ga 1" or 1.5"
OP-What were your previous cycles?

I agree do it right or dont do it.

[ramacher]

o ya with 1" needle kinda hard to miss. I was using a 1/2 inch needle.