pin size for quads

[spoon69]

Ok so i see a lot of people saying 1 1/2 pin is what you have to use for injecting but i use 25g 1 inch push it all the way in and it seems fine. i feel like if the pin was longer i would bottom out or something. is it absolutely a bad idea to use 1inch to pin quads ?

[Capebuffalo]

25 g 1 in gtg

[stpete]

1" is fine. 25's take too long to inject for my taste.

[Noles12]

1" is fine. 25's take too long to inject for my taste.

I agree depending on the solvents.

I have no problem injecting EO based gear through a 25.

Thicker oils I would recommend 23's

[austinite]

23g 1" - sometimes 22g

[Capebuffalo]

For me the smaller for quads the better. Just takes a little time to push through.

[austinite]

For me the smaller for quads the better. Just takes a little time to push through.

That's what she said.

But yes, I pinned 25 before and it certainly was a lot easier. I think after pinning so many times I just became a bit impatient. Although I do try and keep my pinning rate at 1 minute per ML, which certainly cut down on any discomfort.