Just got my gear in. Ordered 4 10ml vials of Test-e. 3 out of the 4 vials look like there's a jelled substance. Any ideas?
Just got my gear in. Ordered 4 10ml vials of Test-e. 3 out of the 4 vials look like there's a jelled substance. Any ideas?
I don't plan on running this cycle until April or May. Would it hurt to leave it in this state until then or reheat now and store it until I'm ready to use it? Also what's the best procedure to reheat crashed gear? Thanks for the reply.Originally Posted by Bio-Active
I would reheat it now to make sure it doesn't crash again. Place the vial on your stove medium heat until it dissolves. Should take more the 30 seconds or so
Just heat a bit of water in a sauce pan and sit the vial in it (maybe half submerged) for a few minutes.
Originally Posted by Bio-Active
Ok I just reheated it. Took about maybe 2 mins. Gear looks good now. Just did one vial gonna monitor it over the next couple of days. What should I do if it crashes again? I apologize for the questions I just never had this problem before.
let's hope it doesn't. Store it at room temp out of the sunlightOriginally Posted by yardbirdaj
I appreciate the advice.
glad it worked out and no problemOriginally Posted by yardbirdaj
I've been reading some other methods of re-suspending crashed gear. A lot of the methods recommend piercing the rubber stopper to alleviate pressure build up in the vial. Is this necessary? And did I screw up by not piercing the top?
no you don't need to. Your fine the way you did itOriginally Posted by yardbirdaj
There are currently 1 users browsing this thread. (0 members and 1 guests)