Crashed gear???

[Frazierboi]

Ok so a good friend of mine ordered some gear and when it came there are crystals in 3 bottles after some research of ppl saying put it boiling water or in the oven at 250 degrees just tryn to figure out which is best or does he just need to do away with it? Tren E and two bottles dbol and oxy mix was like this thanx for the help

[OnTheSauce]

The dbol u can just shake. It doesn't have to heat up and suspend like Tren. I use boil on the stove method

[panntastic]

Ok so a good friend of mine ordered some gear and when it came there are crystals in 3 bottles after some research of ppl saying put it boiling water or in the oven at 250 degrees just tryn to figure out which is best or does he just need to do away with it? Tren E and two bottles dbol and oxy mix was like this thanx for the help

Do not put in the oven
The boiling water is fine

[Iron-56]

Stick a needle in the rubber stopper before you heat the vail as pressure will build up inside. Let it cool and make sure it does not crystallize again. The last thing you want is the solution crystallizing in your muscle.

[Papa Smurf]

Stick a needle in the rubber stopper before you heat the vail as pressure will build up inside. Let it cool and make sure it does not crystallize again. The last thing you want is the solution crystallizing in your muscle.

Your not boiling the compound!!

Op bring water to a boil, remove from heat, insert vial, let stand for 15 to 20 mins........

[boz]

Your not boiling the compound!!

Op bring water to a boil, remove from heat, insert vial, let stand for 15 to 20 mins........

Exactly what i did with my clen some months ago. An idiot friend of mine decided to stick the clen in his fridge, it went off obviously. Gave it back to me, i knew straight away what to do, after 20 mins in boiling water the solution came back to normal, i believe it was not as potent though.

[panntastic]

Stick a needle in the rubber stopper before you heat the vail as pressure will build up inside. Let it cool and make sure it does not crystallize again. The last thing you want is the solution crystallizing in your muscle.

Do not do this
You are leaving your sterile gear open to contamination

[JCFobsession]

I have had two crashed test cyps... I held over stove top for up to 10 min rotating it getting it hot then let it cool down a bit then heat again. Till it was clear and no tiny floater crystals.

[Allaaro]

Before you go trying to cook your vial on a stove....try just running it under hot water as that itself can be enough.

[panntastic]

Before you go trying to cook your vial on a stove....try just running it under hot water as that itself can be enough.

Exactly this
If not running under hot water, placing in a cup of hot water is perfectly ok

[Lunk1]

Exactly what i did with my clen some months ago. An idiot friend of mine decided to stick the clen in his fridge, it went off obviously. Gave it back to me, i knew straight away what to do, after 20 mins in boiling water the solution came back to normal, i believe it was not as potent though.

HUH? Clen is recommended to be refrigerated to increase the short life of the product.

[lovbyts]

Stick a needle in the rubber stopper before you heat the vail as pressure will build up inside. Let it cool and make sure it does not crystallize again. The last thing you want is the solution crystallizing in your muscle.

Do not do this
You are leaving your sterile gear open to contamination

Agreed, no need for a needle/vent. You wont build enough pressure to cause any problems.

[Iron-56]

Agreed, no need for a needle/vent. You wont build enough pressure to cause any problems.

Thanks for the clarification. Never had an issue with gear crashing but I read once of a guy who had his rubber and metal piece pop off due to pressure build up and wound up spilling gear.

[Frazierboi]

Thanx guys for all the help he fixed them boiling water did the job thanx for all the help fellas