Got some gear a few weeks back. Some of the vials are very thick. Ran them under hot water and that seems to help a little. Has anyone every ran into this before? Any suggestions?
New Member
Got some gear a few weeks back. Some of the vials are very thick. Ran them under hot water and that seems to help a little. Has anyone every ran into this before? Any suggestions?
Knowledgeable Member
What gauge pin you using to inject?
New Member
depends on the site
22g in dorsal gluteal
23g in vastus lateralis
I draw it with 18 g
Some of the vials are just so thick and some are a more regular consistency
Knowledgeable Member
Hmm those should be fine I've been having some slow injections with T400 and deca through a 25G pin.
Knowledgeable Member
22g for everything.
You have a hard time drawing through an 18g?
Last edited by Mp859; 11-11-2013 at 12:20 PM.
Senior Member
Some gear is thicker then others.
Last edited by Bert; 11-11-2013 at 07:41 PM.
New Member
Yeah kinda it takes about five minutes to draw up 2 1/2 ml with the 18 g
Senior Member
Agreed. 22 and wholly smokes yo can't draw through an 18? The same compounds from the same lab in other vials are much thinner? Sounds sketchy mangOriginally Posted by Mp859
Senior Member
Maybe youre just experiencing vacuum. try injecting like 3 ml or air into the vial
Knowledgeable Member
How long does it take to inject if its that slow drawing it with an 18G???
Banned
Cant never take 5 Mainz wiv n 18 pin. Don't believer there's a carrier/compound dose that could do that. Its not the compound you see. Its the oil which creates the most thickness. Juss really dont sound right. Gettem swapped if u can
Senior Member
I still think It could be vacuum pulling on the oil back in.
Senior Member
I always inject 1.5-2 mls of air into the vial when I draw out test. Works 60% of the time, every time.
MONITOR
sounds like it
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote