Here is the situation, I was chatting with a buddy while he was doing his shot of test in his delt. I watched him aspirate and as he did his oil changed from the typical yellow(ish) to a milky, cream looking substance. Not the whole syringe, just a bit in the end closest to the pin. He withdrew (cause it scared him a bit but not painful by any means). Ejected the little bit of milky substance into the sink, tossed the syringe, reloaded a new pin from the same bottle of Test-E, switched delts and repeated without any issues. He grabbed the bit he ejected in the sink and kind of rubbed it between his finger and thumb. It was kind of like "snot".
I asked him if it had any smell (thinking maybe infection in his muscle) he said no. I asked if hes ever had a bad delt shot in the past, abscess or anything like that. He cant think of anything other than a couple bad glute pins..he isnt in any pain or discomfort, hell, he's probably already forgotten about it hahaha...(I sure as f**k haven't)
Anyone else have this happen? Is it possible that he could have aspirated some residual oils from a previous injection into the needle? He rotates thru 6 injection sites, and only pins E3D, so it had been a while since he pinned that area last. I told him to stick a new pin back in there and try to draw out some more but he wouldn't go for it...
I mostly pin my delts (I suck at rotating sites like I should) never have i seen my gear change color while aspirating...but I'm only one cycle deep, maybe those with more experience have seen this before?