oil coming out after injection?

[Shaman23]

hey bros i had a question.. I'm doing 500mg test enth a week split into 2 injections. I've been shooting the quads rotating from left/right mon/thurs because it's the easiest to shoot. This is week #4 and I just hit the right quad and after I was done oil/blood came out.. wtf is going on? do i got anything to worry about? I aspirtated and i got air so not sure whats up?

[skii96]

Just inject a little slower. It takes time for the oil to be absorbed by the muscle. The little bit of blood that comes out is normal.

[Shaman23]

I think i was going pretty slow. Im using a 25 guage and it took me about 2 minutes to shoot 1cc.. i think that is a good enough pace or should I go slower?

[Zues]

First, what gauge needle are you using, and second are you aspirating the syringe before you inject (pulling back the stopper to see if you hit a blood vessel)

[Shaman23]

First, what gauge needle are you using, and second are you aspirating the syringe before you inject (pulling back the stopper to see if you hit a blood vessel)

I'm using a 25g 1inch and i always aspirtate..

[LuvMuhRoids]

No big deal it happends. Does it to me sometimes. What I do is have an alcohol swipe ready in front of me and as soon as I withdraw I grab the swipe and press down on the spot of injection to stop this. Then after applying pressure a minute or two I gently massage the area to disperse the fluid through out the area. LMR

[mass junkie]

Happens to me too....I just lick it up

[Da Bull]

A good thing to do is stretch your skin before you inject,push oil in slowly,take needle out and let go of skin.The skin will come together and no oil will be released....give it a try bro..

DB

[Hitman]

I just stick the **** in then when finished leave it in for a minute or so then pull out the pin and put a swab over it..................HITMAN