and more importantly, the steps taken before inserting the needle? its one thing to read things, its another to actually see it done properly
and more importantly, the steps taken before inserting the needle? its one thing to read things, its another to actually see it done properly
I'd hit up the youtube and type inject steroids or something to that effect. You probably will find something.
Then I would dig around on the education threads, as there is metric load of things on this.
I agree from above. There are plenty of vids on youtube. Take a look and you will see.
i checked out some youtube ones but its hard to see everything they are doing. Im more interested in seeing how air is draw in, what items are exactly needed, the steps taken, etc.
Just saw a vid on youtube where they tell you to inject like a dart. Quickly pushing into the muscle.
I like to do it slow and controlled, aspirate, inject, pull out.
ya watch trainspotting
Never injected yet, but since I've read a few threads
Its pulling the needle pludger back before pushing it in. If you draw blood your no a no go for inject. Time to restick your ass and try again.
Read some threads brother there is some good.. though I also understand ur excitement. My guess is after you got your excitement out of the way, be sure you read some PCT stuff and have everything on hand before even think about injecting.
type eurobolic into youtube ,some good stuff , all you will need to know about prep.
When you aspirate you aspirate slowly and if you see blood start to go into the syringe stop and pull outl. You might get a LITTLE blood in the oil but if you're careful you wont get too much. It's only happened to me once where i needed to repin myself. You should change out the needle though for sure. Most will prolly say to change the whole syringe and re-draw a new measured dose but i didnt and i was fine.
Its your blood it came from your body, but I would suspect it's probably not going to hurt you least not that much. Unless your drawing a out a metric ton of blood.
There are currently 1 users browsing this thread. (0 members and 1 guests)