pin size for t400

[norburt]

just curious what size needle gauge is recommended for test 400. either way its gonna feel awesome. LOL what u recommend fellas?

[38jumper38]

23g 1" or 1/2", if you have amps you need filter needles to draw the test out (after you break the top of amps), then switch the needle.

[xxblazenlowxx]

Double post

[xxblazenlowxx]

I thought 23g is recomended length is dependent on where your injecting (1 1/2 glutes) and I don't think filters are needed for amps but either way you can't draw with a filter it will destroy it, you can only push out with filter installed.

Maybe someone will will chime in about filtering amps? I used amps on my cycle and my bro's and I didn't filter.

[ufc8581]

yea i didnt think u needed to filter with amps ..havnt heard that before

[Far from massive]

You don't have to (filter with ampoules) but you can. A filter needle is not a syringe filter, it is a small filter built into a thin tube that attaches just like a needle and inserts into the amp just like a needle, hence the name filter needle. And yes you can suck the mixture up into them with the syringe then when the amp is empty remove the filter needle attach the injection needle and all is well.

[X83]

Glute injections: 23 gauge 1.5 inch long needles.
Thigh injections: 25 gauge 1 inch long needles.
Deltoid injections: 25 gauge 1 inch long needles.

[norburt]

Thanks to all above-
Glute thigh deltoid how often do you alternate injection site?

[cro]

1/2" ?????

23g 1" or 1/2", if you have amps you need filter needles to draw the test out (after you break the top of amps), then switch the needle.

[38jumper38]

Thanks cro, I mean 1" or 1 1/2" and filter needles its not mandatory but its better to be safe that sorry, you don't wanna end with a piece of glass in your glutens ending up in a hospital? rite?

[protrac231]

If you are talking about T400 in a bottle, warm it up in some hot water. It will draw out real nice. Thats what i do 2 times a week, and it works well with 23ga 1.5"

[norburt]

If you are talking about T400 in a bottle, warm it up in some hot water. It will draw out real nice. Thats what i do 2 times a week, and it works well with 23ga 1.5"

you warm up the entire bottle each time? hot than cold numberous times doesnt effect the product? so u just hold it under the faucet or let it float in hot water?

[ButterflyBuffalo]

all depends on where you are planning to inject?

[protrac231]

@Norburt, no warming up the bottle wont effect the product. Just dont boil it. A cup of hot tap water doest the trick everytime. Kind of like if your gear crashes.