research nolva

[cbpumped]

anyone use any research company nolva. I got some pnp brand and it is full of white particle solids. I figured it is enert stuff but I was wondering if anyone had anything to add. I'm using a 23g to draw it out if that matters.

[TheMudMan]

I almost always use pnp...... good stuff...... That's how the nolva looks. You are drinking the nolva correct?

[cbpumped]

yep I'm drinking it but was wondering if a 23g was to thin since it won't suck the white crap up very well.

[TheMudMan]

I use a 20g pin and it works fine.

[SLUMPBUSTR]

i had some about a year or so back and it completely hardend up on me. when that happens, or if its to hard to draw up with a syringe you can boil a small amount of water, take it off the stove, put the pot on a towel and set the bottle in the water with either the cap off or with a 18-21 guage needle in it and it should go back to a liquid. worked for me

[symatech]

that white stuff is the nolva preciptating. heat it until it is all disolved. if you only eat the clear solution and not the particles you are no where near 20mg/mL

[groverman1]

True you need to heat the nolva if there is a lot of white stuff which is the tamoxifen. Otherwise you could be getting little to none nolva.

[TheMudMan]

True you need to heat the nolva if there is a lot of white stuff which is the tamoxifen. Otherwise you could be getting little to none nolva.

I read about doing that before and heated my nolva and it never disolved...... had the same problem with the clomid and it cleared up

[symatech]

I read about doing that before and heated my nolva and it never disolved...... had the same problem with the clomid and it cleared up

i used pnp nolva and it dissolved. i just put it in a pan with water in it and set it on the stove for a bit, shake it around, it will dissolve.

[TheMudMan]

i used pnp nolva and it dissolved. i just put it in a pan with water in it and set it on the stove for a bit, shake it around, it will dissolve.

I will try it again...... I only use pnp stuff........ Thanks

[symatech]

it did take longer than the clomid did. not more than 5 minutes though. good luck!

peace

[cbpumped]

so heat it or boil it?

[TheMudMan]

heat it up.

[cbpumped]

thanks I'm on 40mg dbol and 500enanthate and man the dbol ****s with my nipples every time. Nothing else has ever given me problems. I even took ad50 without issue but it doesn't turn to estrogen either. I have some pills on hand as well and liquidex which i'm saving for my big cycle coming up.

[cbpumped]

I heated it up and spun it in the water pan as it heated up and sure enough it worked. Man I took some right away and it shot right into the syringe. I can tell a big difference now the taste is much more nasty than before.

[TheMudMan]

it did take longer than the clomid did. not more than 5 minutes though. good luck!

peace

It was a lot longer than the clomid but it worked..... thanks bro!

[fitnessNY]

I heated it up and spun it in the water pan as it heated up and sure enough it worked. Man I took some right away and it shot right into the syringe. I can tell a big difference now the taste is much more nasty than before.

You can also get empty gel caps and shoot the NOLVA into the gel caps and take it that way. No nasty taste

[Kdog@usi]

my pnp nolva had the white particles too, I thought I was gonna have to get some great big needles to draw it, but I just tried heating it in water and prsto clear!! thanks symatech.