What is the best way to use masterone ?? It is 100 mg / ml.... Will be running it with test and tren... Was thinking 100 mg EOD but not sure for how many weeks to go with it.. Is 8 weeks long enough or is it usally used longer???
What is the best way to use masterone ?? It is 100 mg / ml.... Will be running it with test and tren... Was thinking 100 mg EOD but not sure for how many weeks to go with it.. Is 8 weeks long enough or is it usally used longer???
Did you check the profile on it?
Of course... It does not say how long most people use it just the dose.. Any feedback???
8 weeks is fine man. Its a short ester. I would go with ED shots though. 75mg ed is good. Wouldnt go lower than that, many people use 50mg ed of shit, like prop or masteron or NPP and just regreat it after. Make it atleast 500mg per week imo.
thanks bino!! I was going to use tbol but that kinda fell through.. Do you think masterone is a good chioce?? I know alot of people say you must have low BF% to get good results with it but from what I have been researching and told that is not true.....Originally Posted by C_Bino
Well yes a low bf% would be better. But I kinda think that is true for any compound really. One thing is for sure I wouldnt use masteron during a bulking cycle. More pre-contest cutting type runs. What is your bf% at now?
My last cycle was a clean bulk so I am sitting right at about 14% BF.. And going to be cutting next cycle... What do you think??
Think it is better to just go with the prop and tren and save the masterone???
Well can you get your bf% down a few points before your cycle starts?
Yea I can do it that way.. I was going to start in a few weeks but could put it off and get my BF% down ...Originally Posted by C_Bino
Ya why not give it a go. Try to get it down a bit, I mean Im asuming you want to cut anyways based on your cycle and wanting to use Masteron so try to spank it down a bit and then try it. If not tren and prop will yield very good results and then you could always use masteron next time around.
Thanks Bino!!!
There are currently 1 users browsing this thread. (0 members and 1 guests)