Thread: Hows this cycle look???
02-14-2005, 10:30 AM #1
Hows this cycle look???
02-14-2005, 10:37 AM #2
Has he been using test cyp as HRT?
you need to give us more info than this
02-14-2005, 10:39 AM #3
02-14-2005, 10:46 AM #4
you arent answering the question bro.......
is he on cyp as HRT? and how long has he been on, and his plans for how long to stay on?
this will matter, depending on where he wants to put the dbol in.
orals like this are best run either in the beginning or towards the end of a cycle. give more info, and we can better help him...........
02-14-2005, 11:01 AM #5
sorry guys but whats HRT....
02-14-2005, 11:01 AM #6
Hormone Replacement Therapy
02-14-2005, 11:04 AM #7
oh ok my bad sorry guys, yes hes been using it for like a couple of years as HRT and now wants to take it to the next level by stacking it...
02-14-2005, 11:07 AM #8
Do you know how much hes getting from the Doc?
Might wanna tell him to save it up untill he has enough for a nice cycle. Run Dbol for the first 4 weeks, and then Cyp at 500mg/week for 10 or 12 weeks., followed by proper PCT. I duno why hes taking a-dex once a week?..
02-14-2005, 11:11 AM #9
he said for the sides, he uses 1cc a week and has plenty ready for cycle.....
02-14-2005, 11:14 AM #10
which would you guys prefer test cyp or test ethanate
02-14-2005, 11:15 AM #11
I understand that he uses a-dex for the sides, water retention, whatever...but its usually taken every day.
If he has enough to run 2 cc/week for 10-12 weeks then let it rip...
02-14-2005, 03:17 PM #12
i like enan better, the taper out time is shorter, and the actual dose itself is higher based on the molecular structure.
in other words theres more test in enan vs. cyp per cc.
but if you like a long slow taper out time, then cyp is for you. especially if youre stacking it with another long chain ester like deca .
like the bro above stated, when he's ready to start his big run(400-500mg per week), then add the dbols in, either in the 1st 4 weeks or the last 4.
remember though, if he adds it in at the end, he has to adjust for the taper of the cyp......
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)