TITANIUM

How to use sachets:

The easiest way to take the steroid out is the same as taking it out from a vial:

1. Before drawing the steroid out of the sachet, it's recommended to warm it up somewhat as the oil is less dense when warm - You can do that simply by placing it over a hot cup of water and the steam will heat it up in half a minute. Don't actually put it in water as you might heat it up too much.

2. Prepare your needle/syringe, then pierce the corner of the sachet. Only pierce a quarter of an inch deep, and make sure you do that at a right angle so the needle won't get out on the other side.

3. Start drawing the plunger immediately or the oil could drip out at the sides.

4. You need to drain the sachet completely - you can't keep the steroid substance inside once you've opened it.

5. If you won't use the whole 3 ml in one shot, you should drain the sachet completely and then inject the liquid into a multi-dose vial and store it for later use. If you don't have a vial at hand, you can also store it in the syringe for few days. (replace the needle immediately after use and put a fresh needle on. Keep the syringe in a dry and dark place at room temperature).



Best

T