Heating syringe method

[Discipline_1]

i also am a fan of heating up before injecting, it def helps a little, plus ever since i have started heating up the compound before injection i have not got the test flu

Thanks guys, i just thought the plastic or rubber stopper would melt a bit due to the heater.

you would need quite a bit of heat to melt the rubber stopper, a heat gun might do it, but i doubt a hair dryer will

i sent a question to the lab that produces the gear i buy asking about heating the compound up regarding on how much heat it would take to potentially alter the compound or affect it in any way but i havent received a reply, does anybody know at what point could heating the compound be potentially damaging to the compound?

[alexs]

i also am a fan of heating up before injecting, it def helps a little, plus ever since i have started heating up the compound before injection i have not got the test flu



you would need quite a bit of heat to melt the rubber stopper, a heat gun might do it, but i doubt a hair dryer will

i sent a question to the lab that produces the gear i buy asking about heating the compound up regarding on how much heat it would take to potentially alter the compound or affect it in any way but i havent received a reply, does anybody know at what point could heating the compound be potentially damaging to the compound?

Boiling point maybe? Turns it to vapor.