Getting test out of amps and into syringe

[trueX]

Yes your needle is to small, the amp is vacuumed and your are drawing something thick like motor oil. Get "Blunt" or "Draw" needles they are large gauge and designed just for drawing up medications pre-injection. Mostly any 16-18g would do but I stick the the "blunt" needles and then change out my tip to a fresh clean sharp 23g 1.5 inch. 22s are gonna hurt a small bit imo bro

[T-MOS]

Yes your needle is to small, the amp is vacuumed and your are drawing something thick like motor oil. Get "Blunt" or "Draw" needles they are large gauge and designed just for drawing up medications pre-injection. Mostly any 16-18g would do but I stick the the "blunt" needles and then change out my tip to a fresh clean sharp 23g 1.5 inch. 22s are gonna hurt a small bit imo bro

amps are NOT vacuumed, VIALS are vacuumed, amps are open glass that you break the tip off of to get the juice

[trueX]

amps are NOT vacuumed, VIALS are vacuumed, amps are open glass that you break the tip off of to get the juice

OOPS, you are correct, sorry I was reading him saying AMPS and thinking of my Vials lol. Correct for amps just snap the damn top off with your hand and draw it SLOWLY not pulling air in, you can do it fine with a 22g, just go slow, overfill by about .5 ml and let the bubble then float to the top, using the extra .5ml of space to push air out leaving you a full syringe

[1down5up]

Pull the plunger back all the way and stick in the amp. Push the plunger down all the way with the needle in whatever your drawing. Then slowly start pulling the plunger back up. Should come out then. Just did it 5 minutes ago with a 23g pin.