what am i doing wrong here?

[millionairemurph]

I am finishing out my aas cycle with some peptides. I plan on running them through pct. I am hitting a snag however. I have cjc 1295 and ghrp-6 in 2ml vials. I have 100iu insulin syringes.

After i draw out the amounts i need of the cjc and ghrp, the pin is realy dull. I have to jam it where it hurts worse than the 25 ga pins i use for regular injections.

I have tried to draw with one and then pull the plunger out and fill another one only to find out that the water stays near then pin end and when i put the plunger in it squirts out. I need air to go through the pin into the syringe.

What is a good way to draw and inject these peptides? The unused insulin pins dont hurt a bit, dont leave a mark and dont bleed, but i cant figure a way to fill one.

[JimInAK]

I have the same problem when I use Chinese blue top HGH. The rubber plug is tough and it dulls the pin. I used to use Easy Touch Insulin Syringes, but I would often bruise and really had to use force to get through my skin. I never had that problem with those pins for insulin, as the top of the insulin vials were much easier to penetrate and didn't dull the pin.

I switched to BD Ultra Fine Insulin Syringes and they worked much better, never caused bruising and seemed to stay much sharper. They cost about 3 times more, but they are worth it if you are need them for a tough job.

Otherwise, I'd consider buying separate pins from syringes and use a fresh needle for your injection. However, I've never had to try that as the BD's solved the problem for me.

[DCannon]

I use the BD Ultra fine as well and I've never had a problem. How long have you been on the peptides now Murph? How are you taking them?

[millionairemurph]

I use the BD Ultra fine as well and I've never had a problem. How long have you been on the peptides now Murph? How are you taking them?

I'l try those pins. This is the third day. Taking them im with my daily aas shots for the next few weeks. The other shot i"m taking daily is im too i guess, the pin is 3/16 i think and i just jam it in hard and fast. If i go slow like i do with the 25 ga pins it just dents my skin. Ouch!

[bullmastiff]

What I've done sometimes is score the side of the aluminum and pull the cap off. Then you can pull the plug out. I've done this when I've had to do two in an injection.

I store the vials in a used medicine vial that has been cleaned with alcohol very thoroughly.
I use tape to make sure the plug stays in just to be safe. It's just an alternative if your careful.

[ScotchGuard]

I've heard of people pulling the cap and the plug off the vials, load the syringes, and put the syringes in the frig to be used as needed.

[higherdesire]

not a popular option I am sure but you can draw with another lur lock pin, remove the pin, then use the slin pin by dipping it in the open end where you removed the lur pin. You will need to slide the plunger up while drawing but it is one way to not have your end dulled if it is that big of a problem. Good luck

[higherdesire]

I always load a week in advance BTW