Mix 100 syrigne units of bac or sterile water to the 10IU vial.
Then each 10 syrigne units = 1IU.
Ie, 25 syrigne units = 2,5 IU of HGH.
Later, if you buy 8IU vials instead of 10IU you can mix 80 syrigne units to make it easier for you to messure.
Mix 100 syrigne units of bac or sterile water to the 10IU vial.
Then each 10 syrigne units = 1IU.
Ie, 25 syrigne units = 2,5 IU of HGH.
Later, if you buy 8IU vials instead of 10IU you can mix 80 syrigne units to make it easier for you to messure.
1 cc is an excessive amount of water to mix for a 2 iu injection. Dinko's explanation is the standard way to mix HGH, from my experience and is what I use.
The thing to remember is that 1 cc = 1 ml = 100 iu's on an insulin syringe.
What I do and what Dinko explained is that for a 10iu vial, dump in 1 cc of bac water. Then what you have is about 1 cc of reconstituted HGH (or 1 ml or 100 iu's in an insulin syringe.. all the same amount).
Now, one single iu from the insulin syringe equals one tenth of an iu of HGH. So if you are taking a 2 iu HGH dose, you will take a 20 iu injection.. a ten to one ratio... easy to figure once you understand it. If you want a 4 iu injection, that would be a 40 iu shot from an insulin pin, etc.
Hope that's helpful...
JiminAK,
So what you are saying is to take my 1ml syringe, fill that one time and dump it into the vial.
Then 20 marks out of the 100 on this 1ml syringe will give me 2iu. Is this correct?
When I was taking hCG, I initially had the stuff concentrated so that each shot was 0.4ml.
Lots of my hCG got wasted this way, because every little droplet had a fair amount of hCG in it.
So I further diluted it so that each shot was 0.8ml. I found this easier to measure, and I wasn't as worried about losing a droplet here and there.
One tip: I find Sub-Q injections into abdominal fat are a lot better if you sit down to do them, all the blubber comes out![]()
There are currently 1 users browsing this thread. (0 members and 1 guests)