IM with slin pin

[johnnymctrance]

I posted a very similar thread not long ago,

The end verdict seemed to lean towards the fact that oil based steroids would be to thick to be pushed through a slin pin!

Good luck

[Red Bastard]

I posted a very similar thread not long ago,

The end verdict seemed to lean towards the fact that oil based steroids would be to thick to be pushed through a slin pin!

Good luck

Not true at all! Funny how people will give advice on something, without any personal experience....

I have used 29gx1/2" pins for oil based test. It injects quite easy, on account of the narrow diameter of the syringe barrel.

Now, where the difficulty arises, is loading the syringe. Drawing up the oil takes a long time. To get around that, one loads into a standard 3ml syringe, and then carefully "back-loads" the slin pin. Sounds tricky, but it's actually quite easy. Just be careful when you reinsert the plunger, as you need to simultaneously invert the slin pin, to allow the air bubble to rise to the needle end, so that you don't lose some oil in the process...

[johnnymctrance]

Not true at all! Funny how people will give advice on something, without any personal experience....

I have used 29gx1/2" pins for oil based test. It injects quite easy, on account of the narrow diameter of the syringe barrel.

Now, where the difficulty arises, is loading the syringe. Drawing up the oil takes a long time. To get around that, one loads into a standard 3ml syringe, and then carefully "back-loads" the slin pin. Sounds tricky, but it's actually quite easy. Just be careful when you reinsert the plunger, as you need to simultaneously invert the slin pin, to allow the air bubble to rise to the needle end, so that you don't lose some oil in the process...

As I mentioned, I was only saying what the main reply was in the thread I started! i was in no way giving definitive advice... There was clearly going to be other people yet to comment with their own personal experience!