*VIDEO* How To Inject - Instructional Video on Proper Injection and Dosing

[Low Testosterone]

With regards to not wasting that .1ml of test, when you draw back on the syringe to put that extra .1ml back into the syringe rather than wasting it in the hub and needle, do you actually inject that? Isn't that an extra .1ml above and beyond your dose? You would still run out early. What's the correct way to save that .1ml?

Always draw out exactly what you're supposed to take. If you're supposed to take 100mg, draw out exactly 100mg. When a guy starts thinking about all these little factors, 99% of the time he screws himself. So with 100mg you would draw out to half a ML, not 0.6, not 0.63. not anything past 0.5. And when you inject, if there's anything left in the hub of the needle, well that's what's left in the hub of the needle but you didn't take out more than you were supposed to from the bottle of testosterone and that's what matters.

Running out early is a big deal.

[LFH40]

Always draw out exactly what you're supposed to take. If you're supposed to take 100mg, draw out exactly 100mg. When a guy starts thinking about all these little factors, 99% of the time he screws himself. So with 100mg you would draw out to half a ML, not 0.6, not 0.63. not anything past 0.5. And when you inject, if there's anything left in the hub of the needle, well that's what's left in the hub of the needle but you didn't take out more than you were supposed to from the bottle of testosterone and that's what matters.

Running out early is a big deal.

I really appreciate your response to my question, thank you! I only ask because of the video, it shows him pulling back on the plunger before taking the drawing needle off as to not waste what was left in the hub. When I do that, I end up with more than .5 on my syringe. I know I'm overthinking this, but I'm afraid to incorrectly dose myself or to run out a little early.