Drawing and Pinning with the same needle

[numbere]

It will be more painful when pinning because the needle will be duller.

Plus the whole process takes a lot less time if you draw with a larger gage (22-18) and pin with a smaller gage (25-26).

Personally I can't make sense of drawing and pinning with the same needle because a box of 100 brand name needles costs 6 or 7 dollars.

[csky]

It will be more painful when pinning because the needle will be duller.

Plus the whole process takes a lot less time if you draw with a larger gage (22-18) and pin with a smaller gage (25-26).

Personally I can't make sense of drawing and pinning with the same needle because a box of 100 brand name needles costs 6 or 7 dollars.

How do you have the patience to pin with a 25 guage... 23 is as slow as I can handle it

Sent from my SM-G950U using Tapatalk

[magic32]

It will be more painful when pinning because the needle will be duller.

Plus the whole process takes a lot less time if you draw with a larger gage (22-18) and pin with a smaller gage (25-26).

Personally I can't make sense of drawing and pinning with the same needle because a box of 100 brand name needles costs 6 or 7 dollars.

When using gear, I concur, maintains sterility too.

Unless you're as tough as Guitarzan (see his post).

[guitarzan]

When using gear, I concur, maintains sterility too.

Unless you're as tough as Guitarzan (see his post).

That's not being tough, I had to inject with 18ga before! Back years ago, before I was a internet shopper, I pretty much had only one place to get syringes from in my little shit town. One time they asked what I was doing with them and I said injecting grease into sealed bearings. He said I know what you trying to do, you need 18ga! So that's what I used for a little while, them fuckers hurt! Your skin would press in a couple inches before the needle would penetrate. You pretty much have to put a bandaid over the hole when done

[diesel101]

That's not being tough, I had to inject with 18ga before! Back years ago, before I was a internet shopper, I pretty much had only one place to get syringes from in my little shit town. One time they asked what I was doing with them and I said injecting grease into sealed bearings. He said I know what you trying to do, you need 18ga! So that's what I used for a little while, them fuckers hurt! Your skin would press in a couple inches before the needle would penetrate. You pretty much have to put a bandaid over the hole when done

Lol
I screwed up and ran short one time and had to goto walgreens for syringes. They asked what I was injecting and I used the grease in bearing excuse.