Testo E 300 - painful

[Noob_monkey]

Hiya!

Any advice for reducing the pain.. After using test e 300mg, my leg is really hurting for 2 days after.

Used a 250mg before and was much more comfortable.

Any way to make it a bit more manageable?

Cheers!

[Cuz]

Inject less volume more frequently. Change sources. I prefer test E 200mg its pretty smooth

[scotty51312]

buy a vial of sterile grape seed oil or cottonseed oil, cut your test 1:1 with it and you'll have no problems. Will be injecting larger amounts so stick to glutes, quads, possibly delts if 2ml or less. Like cuz said injecting less more often helps. I use test 400 e which hurts like a mofo, but cut with GSO I have no issues

[Noob_monkey]

buy a vial of sterile grape seed oil or cottonseed oil, cut your test 1:1 with it and you'll have no problems. Will be injecting larger amounts so stick to glutes, quads, possibly delts if 2ml or less. Like cuz said injecting less more often helps. I use test 400 e which hurts like a mofo, but cut with GSO I have no issues

Awsome.. Thanks you two!!

Will get the oil

[ghettoboyd]

If your using any other injectable like deca just mixing the two into one injection will lessen the pip considerably as opposed to gso taking up more room unnecessarily in the pin...2cents

[Yard_Dog]

Where are you injecting? Ventrogluteal or Upper outside quad should be practically painless with 23 guage 1 inch.

[Charlie67]

Try Bold Ace for a week, you'll realized you gear feels like a blowjob.

[Meow_Wolf]

Go for delts, and glutes (side under hip).
Or dilute and thin it out like I've seen other people say.

[Yard_Dog]

No dead leg.


https://trthub.com/ventrogluteal-glute-injection/

[Hughinn]

I've got some beligas test e 300.

Good stuff, but it does hurt like a bitch. Every pin site swells and hurts a few days.

Some Balkan 250 also, much better. A little pip the next at injection site. No swelling.

The beligas oil seems thicker. Plus the gear is more concentrated. Or so it says.

The pip on the 300 is a bitch though.

[Honkey_Kong]

I've said it in another thread but here is what I've found that helps
1) warm up the gear a little
2) inject slower (that stream coming from the needle can bruise muscle)
3) synchronize your injection locations to your workouts. If you're doing legs later that day, inject in your quads or glutes. If you're doing shoulders, inject there.

And yeah diluting the gear with GSO might help a little bit too.

The pain becomes more manageable the more you do it though.

[AR's King Silabolin]

Hiya!

Any advice for reducing the pain.. After using test e 300mg, my leg is really hurting for 2 days after.

Used a 250mg before and was much more comfortable.

Any way to make it a bit more manageable?

Cheers!

Also inject superslow. I mean real slow. Like 1 min.
Then followed by 3 min massage of the injection spot.

Sent fra min BLA-L29 via Tapatalk

[AR's King Silabolin]

Inject less volume more frequently. Change sources. I prefer test E 200mg its pretty smooth

Wouldnt that lead to more scartissue?

Sent fra min BLA-L29 via Tapatalk

[JdFlex]

Then followed by 3 min massage of the injection spot.

Sent fra min BLA-L29 via Tapatalk

My Dr said not to do this as it will push the oil into fat tissue which is more painful.

[JdFlex]

I've said it in another thread but here is what I've found that helps
1) warm up the gear a little
2) inject slower (that stream coming from the needle can bruise muscle)
3) synchronize your injection locations to your workouts. If you're doing legs later that day, inject in your quads or glutes. If you're doing shoulders, inject there.

And yeah diluting the gear with GSO might help a little bit too.

The pain becomes more manageable the more you do it though.

I've had muscle crippling pain injecting UGL test, but no other type of gear. Doesn't matter the mg/ml. Doesn't matter warming up the gear. Doesn't matter injecting slowly. Doesn't matter injection site. Doesn't matter workout timing.

The ONLY thing that helped was diluting the test with another gear or sterile oil. Zero post pain.

But that's me.

[The Deadlifting Dog]

I've had muscle crippling pain injecting UGL test, but no other type of gear. Doesn't matter the mg/ml. Doesn't matter warming up the gear. Doesn't matter injecting slowly. Doesn't matter injection site. Doesn't matter workout timing.

The ONLY thing that helped was diluting the test with another gear or sterile oil. Zero post pain.

But that's me.

What sort of test were you injecting?

test E, P, C, sustanon, etc...

[AR's King Silabolin]

My Dr said not to do this as it will push the oil into fat tissue which is more painful.

Ah ok. Im No expert on this. Just remembering one of the first steroid injection guidelines i red. "then massage the injection spot"
I do it for like 30 secunds. Never had pain to mention from it. Must be several 100 injections during a 25 years span.

Sent fra min BLA-L29 via Tapatalk

[Hughinn]

I've said it in another thread but here is what I've found that helps
1) warm up the gear a little
2) inject slower (that stream coming from the needle can bruise muscle)
3) synchronize your injection locations to your workouts. If you're doing legs later that day, inject in your quads or glutes. If you're doing shoulders, inject there.

And yeah diluting the gear with GSO might help a little bit too.

The pain becomes more manageable the more you do it though.

That don't work for me. I pin in an ass cheek, then squat later that day, it swells up twice as bad.

My brother, is using the same gear, from the same batch, and nothing at all.

That beligas 300 pins on me like a hornet sting for some reason, and nobody else seems to have the same problem with it. . And working out the muscle makes it worse. Luckily, I'm almost done with it.
But I get pip from just about any shot. Tetanus, flu, you name it.

[Hughinn]

Ah ok. Im No expert on this. Just remembering one of the first steroid injection guidelines i red. "then massage the injection spot"
I do it for like 30 secunds. Never had pain to mention from it. Must be several 100 injections during a 25 years span.

Sent fra min BLA-L29 via Tapatalk

Maybe you ain't got a fat enough ass?

Because it makes it worse for me too.

[Chicagotarsier]

Pain in general, if the injection suspension is sterile and the injection is sterile, comes from 1 of 2 items.

1. Mg/ML I pin 500 Test E and it hurts every time.
2. BA level in your brew (most common cause)

To solve

1. As mentioned above dilute with oil
2. Warm the brew and allow the excess BA evaporate.

[MILKMAN73]

1) As others said, warm it up!

2) Again as others said, inject slow.

2.5) Inject steady! If you are injecting slow, but have the jitters and are twitching the needle around, the tip of that needle is shredding up muscle fibers. So steady hands. Might help to have someone else do it.

3) Sometimes helps to dilute it down. I often used an injectable B vitamin. Water based, so give your pin a little shake to mix up the water and oil. Water based Vit B helps thin it down and is supposedly good for an energy boost. That may be outdated science, though, so double check.

4) This should go without saying, ALWAYS USE NEW PINS!!!

[AR's King Silabolin]

Maybe you ain't got a fat enough ass?

Because it makes it worse for me too.

I tell u, im gonna try your docs advice. My injections are not painfull, but it often leaves a bulp, which needs some 3 weeks to flaten.
Maybe i massage too much, spreading it to the fatlayer at the hips. Luckily im gifted with a very small waist, yet it doesn't look good.
But, if it makes it worse, ill come after u both with a stick lol

Sent fra min BLA-L29 via Tapatalk