What's the best way to draw up that last bit of gear?

[G-S]

Ya know, when ya have just 1cc of oil left in a 10ml vial. Holding it upside down, but my vials have a rubber stopper that is pretty big, and the gear just settles around the side of it when I tilt the bottle upside down...

How does everyone do this?

[Tankass]

read somewhere that just pulling out the rubber and tilting the vial to the side a bit works. I have never juiced so I am not talking from expierience. It is just what I have read. Though it does sound logical.

[G-S]

33 views, and only one response...

[rangerdudeleads]

maybe if you tilt bottle where itll all settle down at corner at bottom and put syringe in there but first push a little air in there and then suck it up that shuld work. I had to stick a buddy the other day and i had a hard time just getting that thick shit in with a full bottle .

[Ole]

Just tilt the botle an use a long pin. No use to flip the botle up side down when there is just one ml left.

Ole

[G-S]

The inch and a half pins I have arent long enough to reach the bottom...

[ironfist]

Grab a pair of pliers, twist the aluminum ring off from the bottle and remove the rubber stopper...You can then suck the contents out from the bottom of the bottle...

I don't do this, I just hold the bottle upside down and at any angle and get damn near all of it out...