Need shorter pins

[brenttonic2]

Im currently using 22g 1 1/2 pins in the glut ed with tren and prop....
where can I get some 5/8 so i can do site rotations?.

any help would be great!!!

[FireGuy]

Sponsor in the top right corner can help you out.

[brenttonic2]

I was thinking locally... like a pharmacy or where....

[CHUCKYthentic]

5/8 sounds short to me IMO. i would go short than 1" and just leave a little sticking out of injection site

[CHUCKYthentic]

i mean i WOULDN'T go short than 1"

[Mammon]

same here..i use 1" for everything except glutes

[johnnybigguns]

Just use the ones you have and don't go in all the way.

[Big_Intruder]

Im currently using 22g 1 1/2 pins in the glut ed with tren and prop....
where can I get some 5/8 so i can do site rotations?.

any help would be great!!!

I personal use 21G 1 1/2" and 23G 1", I don't see the point in going smaller in dia but the length also should not go less than 1" IMO.
Where to get them? Just walk into the pharmacy and ask for them!
They are not illegal.
I just picked up 2 x 100 boxes and immediately the lady behind the counter asked "are they for steroid injection?" Why lie, I told her "yes".
"Do you need swabs also?" she asked.
These people are not stupid and at the sametime in general are not judgmental.
I'm not sure about the US (regarding the law) but if they ask what they are for, tell them you are into S&M and they are to pierce your scrotum,

[JiGGaMaN]

JiGGaMaN says:

You can use the 1.5" ones you have now fine anywhere, just go in as far as you feel comfortable. I've been in the same situation and used 1.5" for delts without problem (im by no means huge). If you feel like switching to 5/8's just to get comfortable with other injection areas, by all means give it a go. The only problem i foresee with that is you end up getting 'lumps' once and a while, likely from not going deep enough.

[T-MOS]

you can also cut the plastic needle cover down an inch and recap the needle, that way when you inject, you only go in an inch

[JiGGaMaN]

you can also cut the plastic needle cover down an inch and recap the needle, that way when you inject, you only go in an inch

woah. very genius.

[hankdiesel]

5/8 for bi's and 1 inch for everywhere else is what I do. I wouls definitely stop shooting your glutes ed as soon as possible.

[Chance_Baby]

i like using a lil bit of a bigger needle incase the pin brakes and you have a lil sticking out so you can just pull it out.

[afigs052377]

you can also cut the plastic needle cover down an inch and recap the needle, that way when you inject, you only go in an inch

nice....wish i would have thought of that