Perhaps a silly question, but...

[Bakabaka]

Been training for about 6 years now and considering doing a simple test cycle for 12 wks in the near future so I've been doing a lot of research.

Most injection guides show them drawing from rubber-stop vials when the gear comes in amps. So this is my question: When you get your amps.. score it.. crack it open.. do you then transfer to rubber-stop vials for storage?

Not sure if this is silly question or not so I apologize in advance, haha.

[D7M]

no need to transfer it.

just draw it from the amp and shoot it.

[Big]

It depends on the usage, if you intend to use the amount contained in the amp for each shot, just draw from the amp and shoot. If (like with sust for instance) you intend to shoot less than an amp, transfer all amps to a sealed sterile vile and draw from that as you wish.

[bifda]

what if you use half and draw the rest into another syringe and store it till next pin day ?

[Big]

what if you use half and draw the rest into another seringe and store it till next pin day ?

I've known many who do that, I always prefer just transferring it to a vial. Personal preference I guess, with sust I would just transfer all my amps at one sitting to a vial and be done with it.

[Bakabaka]

You guys are awesome, thanks!

[WARMachine]

^ I agree.

Make sure to swap the top of these vials after each injection into them.

[alpmaster]

Will you be drawing and pinning with the same needle? If so, I'd transfer it to a vial.