Results 1 to 5 of 5

Thread: Heating test E

  1. #1
    Join Date
    Jan 2010
    Location
    An Linne Rosach
    Posts
    1,437

    Heating test E

    I have a ten ml bottle of test e I have read in threads to heat the test up to make it easier when you pin.My question is it ok to heat the whole bottle or will it damage the test heating it twice a week to draw up and pin

  2. #2
    Join Date
    Oct 2009
    Location
    Here
    Posts
    625
    how thick is it?

  3. #3
    Join Date
    Aug 2009
    Posts
    13,506
    You're fine heating the whole vial. Even boiling water won't damage the hormone. Just let the vial sit in a cup of warm/hot water for a minute while you're preparing for your injection.

  4. #4
    Join Date
    Jan 2010
    Location
    An Linne Rosach
    Posts
    1,437
    Its quite thick thanks thats what I was worried about incase I damaged the hormone

  5. #5
    Join Date
    Mar 2008
    Posts
    4,113
    Personally I wouldn't keep heating a vial. if it is that bad... Run the syringe under warm water.

    Pull fluid into syringe. Swap your needles leaving the cap on. Run the water over the doseage reading. not near the top or bottom. your good to go.. just wipe it off.

    Or some hold in there hands. Or rub their hands together with it in hands etc.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •