27 G X 1/2" needle with 03 CC Syringe for delt inj.?

[The_crippler]

I am going to do my second cycle soon and i am thinking of doing Delt injections instead of the glute. I did the glute om my last cycle and i must say i had a hard time with the injections, i want to try the delts cause i can imagine it is easier to see what you are doing :P

I have been reading about delt injections and i think i have an hang of it.

Iam was thinking of using 27 G X 1/2" with 03 CC Syringe to inject with.

I want to hear you opinion and expreince of using 1/2 " needle into the delts.

Thanks

[dive_kid]

i use one inch 25 guage my self.good for delts quads,bis,tris. good fun

[TxBeef]

1 inch 22 gauge here.

[almostgone]

I am going to do my second cycle soon and i am thinking of doing Delt injections instead of the glute. I did the glute om my last cycle and i must say i had a hard time with the injections, i want to try the delts cause i can imagine it is easier to see what you are doing :P

I have been reading about delt injections and i think i have an hang of it.

Iam was thinking of using 27 G X 1/2" with 03 CC Syringe to inject with.

I want to hear you opinion and expreince of using 1/2 " needle into the delts.

Thanks

what are you injecting? 27ga. may be a little small and you may need to rotate sites depending on the ester/ injection frequency of your medicine...I use a 23ga. x 1" for delts...some prefer a 25ga......1/2" point sounds awful short...hope this helps....

[TheDfromGC]

27ga. would take about 10 mins to inject 1 cc

[Bigkatz]

read. spotinjections.com

[Rhino58]

i usually use 25g but it usually takes forever to inject.

[Countryboy]

My first cycle I was a pain freak well I didn't care if it hurt and I injected every where possible. But I used a 22 ga 1 inch for all injections except my glute and then I used 22ga 1 1/2 inch. 22 ga to a lot in other places but glute hurts. But the smaller ga u go the longer it takes to inject and I like to go in push it in not fast but not slow about moderate and get it done with. I don't think 1/2 is going to be enough to bury the needle deep enough in the muscle. If ur going to stick with that gauge go atleast 1 inch. GL

[Gootch]

I rotated from left to right arm and used front, middle and back of my delts for a six week cycle with a 23G 1" spike and it worked great. I have site shot other areas but the delts are the best fro me.

Good Luck

[gya321]

If you have a drawing needle you can inject with that 27. It just will take some time depending on what gear your using. Ive used the same ones for calves

[The_crippler]

**** , thanks for all the help guys.

I am going to use a 23 g to draw with and use 27 g 1" to inject with.

But what should i expect. any danger of hiting a nerv or vain `? i am going to inject as it is shown on spotinjection.com.

[SouthSideSteve]

Just be sure to aspirate , the chances of hitting a nerve are very remote for delt site.

[Carlos_E]

**** , thanks for all the help guys.

I am going to use a 23 g to draw with and use 27 g 1" to inject with.

But what should i expect. any danger of hiting a nerv or vain `? i am going to inject as it is shown on spotinjection.com.

What are you injecting? Depending on how thick it is you may not be able to push it through that small of a pin. What are you running? Personally I wouldn't go smaller than 25g.

[50%Natural]

Since I'm only the 2nd person on the thread that has used a 27g 1/2 needle, and the first to actually use it in my delt, i can tell you it was just like any other. However, I'm was about 12%bf when i did it and I didn't like it as it left me sore since I didn't get the juice deep enough into the muscle. Ive done it a couple times and prefer the 27g 1/2 for my bi injections but go with 25g 1 for delts. And no, it did not take 10 minutes to shoot 1cc. Ive put test, eq and parabolan all through in the same amount of time it takes a 25g. Good luck.

[The_crippler]

I am going to inject Test e and Equipoise . I am going to aspirate when i inject ,wouldnt have it any other way :P

I will keep you guys informd when i start my cycle.

[fitnessNY]

1 inch 22 gauge here.

22g -- ouch

I use 25g 1" for my delts, pecs, tri's and lats. 25g 1.5" for glutes.

[Carlos_E]

I use 25g 1" for delts, pecs, biceps and lats. 23g 1.5 for quads and glutes. 23g 1" if I hit the tear drops.