Drawing from amps?

[beastrg]

I know how to draw from a vial but how from an amp?

Break the amp top, and then just draw? Do u use a larger guage needle and then change to smaller (i.e. from 21 to 23g) to inject? also u cant push air from the syringe to thwe amp as there is no vacuum can u?

[tempbrit]

Drawing from an AMP is simple. You can use a larger guage needle, but you do not need to.

Simply pop the top off, be careful not to spill or cut yourself. Then insert your needle in the Amp and draw out the juice. If you are using a 23 or 25 guage, be patient.

It is really simple.

[RA]

Use a filter needle if possible.

[BITTAPART2]

you can make sure to get most if not all the oil out if you hit the ampule w/ a hair dryer for a few seconds before opening to thin it out

[tempbrit]

Thinning the oil by warming does help when you draw and inject.

When I open my Amps up and draw, I tend to get about .5ml more than what it says it contains. I typically inject this full amount in.

I am curious if they stick a bit more in the Ampule to deal with the expected loss when drawing. I assume that the ratio of oil to Test would be the same and therefore, I would be getting slightly more than what the Amp says it contains.

Does this make sense. Just curious.