Results 1 to 12 of 12
  1. #1
    frenchy's Avatar
    frenchy is offline Associate Member
    Join Date
    Mar 2007
    Location
    canada
    Posts
    245

    Multi-dose vial sterility??

    Im using a multi-dose vial and im not sure the best way to keep it sterile in between injections??
    Will the hole created by the needle make it not sterile after a while?
    Using a 50ml vial eventually there will be tonnes of holes in the top??
    Need info from the experienced please?

  2. #2
    Benches505's Avatar
    Benches505 is offline 75% HGH 25% Testosterone
    Join Date
    Feb 2004
    Posts
    3,030
    As long as you use a clean needle everytime and wipe the top with alcohol you should be fine. Now if the vial were to leak when held upside down that might be another story.

  3. #3
    hugovsilva's Avatar
    hugovsilva is offline Anabolic Member
    Join Date
    Oct 2006
    Location
    Portugal
    Posts
    2,458
    I always try to use the same penetration spot on the rubber.

  4. #4
    MrMe's Avatar
    MrMe is offline Member
    Join Date
    Nov 2005
    Location
    Ontario
    Posts
    748
    Just wipe the top of the vial with an alcohol swab before each use. The pin shoulndt contaminate it because your using a new pin time, I hope.

  5. #5
    nate4796 is offline Junior Member
    Join Date
    Aug 2006
    Posts
    144
    I just always wipe with alcohol swab and use clean needles. Should be fine.

  6. #6
    Dog-Slime's Avatar
    Dog-Slime is offline Senior Member
    Join Date
    Nov 2006
    Location
    Dirty South
    Posts
    1,139
    You could always buy sterile 10ml vials and swap it into them if you are worried about it.

  7. #7
    gixxerboy1's Avatar
    gixxerboy1 is offline ~VET~ Extraordinaire~
    Join Date
    Sep 2001
    Location
    Texas
    Posts
    32,802
    They are fine. Your body can fight a little bacteria. If your using new pins then there isnt even an issue. You get a little cut on your fingers air hits it it all or a sudden infected and needing antibiotics.

  8. #8
    davedizzle's Avatar
    davedizzle is offline Associate Member
    Join Date
    Feb 2006
    Location
    South West UK
    Posts
    440
    Personally if I had a 50ml Vial i'd split it into some smaller sterile vials. Drawing an entire 50ml with 18g pins will mash the stopper up for sure.

  9. #9
    aadrenaline is offline Banned
    Join Date
    Nov 2004
    Posts
    2,399
    ***ends what gauge needle your draw with...18g will def. tear it up unless u keep going through the same hole...i draw with 25g in my 10mls pain in the ass but w/e.

    also it'll be fine, you gotta start worrying when you get like a fuzzy or hair or somthing like dirt in the vial which isnt going to go through a small hole like that. the BA in the juice will kill the bacteria, BA is nasty shit

  10. #10
    jagdpanther's Avatar
    jagdpanther is offline Member
    Join Date
    Feb 2007
    Posts
    735
    I home brew and use only 50ml vials. Never had a problem. I follow a good Hygine protocol as suggested by other posters -

    1) always wipe down the top of the vial with alcohol
    2)I always use a fresh clean needle to draw.
    3) wipe down your injection spot both before and after injection
    4) If there is any residual oil on the stopper after drawing i make sure it is wiped away with cottonball and alcohol.

  11. #11
    ironpumpindoc's Avatar
    ironpumpindoc is offline Junior Member
    Join Date
    Apr 2004
    Location
    Michigan
    Posts
    134
    definitely use a cleaning protocol as listed; alcohol, and clean pins - store the vial somewhere dry and dark. just FYI whenever we use multidose vials of any medication in most hospitals they are given a 30 day expiration!! for just this reason

  12. #12
    frenchy's Avatar
    frenchy is offline Associate Member
    Join Date
    Mar 2007
    Location
    canada
    Posts
    245
    thanks for all the replies. Now I can proceed with confidence.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •