Crystal in oil

[SMCengineer]

Without going into specifics, I was transfering my Test E from a container that it came in to a 50ml vial. When I got all the oil out I noticed the solution had crashed and there was a thin layer of crystals on the bottom. I tried to get them out by putting a little bit of oil back into the container and heating it, but no luck. The amount was very small, but would this have a noticable effect on the potency of the Test E? I should mention that when I was done I had to heat the rest of the oil that was in the vial because it was cloudy.

[SMCengineer]

It's dosed at 250mg/ml if that helps.

[Ashop]

It's dosed at 250mg/ml if that helps.

the crystals are most likely hormone

[naturalsux]

the crystals are most likely hormone

shouldn't reheating resolve that?

[TheMudMan]

shouldn't reheating resolve that?

It should have but maybe there's too much hormone to keep in solution.

[HORSE~]

It should have but maybe there's too much hormone to keep in solution.

Holy shit dude welcome back!!!!

Still listnig to O&A??

[naturalsux]

It should have but maybe there's too much hormone to keep in solution.

so add more bb?

[TheMudMan]

so add more bb?

Maybe, but then would you know what the dosages are? I'm assuming this is either a UG or home brew batch so you are never sure what the actual dosages you have.

[naturalsux]

Maybe, but then would you know what the dosages are? I'm assuming this is either a UG or home brew batch so you are never sure what the actual dosages you have.

he could email them for the %s and go from there.

[TheMudMan]

Holy shit dude welcome back!!!!

Still listnig to O&A??

Thanks........ been very long time.


LOL...... yep still listening to them on XM