Tiny crystals in vial?

[Focusmen]

It's test prop and it's in 1ml vials. 20 out of 30 of the vials have little white crystal formations at the bottom....Its phara grade and it's def legit. Shakeing it dosent seem to do much. It say prodution 8/9 and experation is 8/11

anyone ever had this problem before. It just looks like pain in a bottle.lol

[tubs]

did you refrigerate?

[Spartans09]

Heat them. I just had the same issue last week. Put a pot on the burner with about an Inch of water in it. Turn the burner on a low setting. Set the vials in standing upright and let them go fo 5-10 minutes then remove and swirl, don't shake. The hormone should now be reabsorbed back into the oil.

[Focusmen]

didnt refrigerate but very possible they were in freezing conditions during shipping (cold the prauge right now .....

Ill try the hot water meathod right now. thanks for the input spartan

[tubs]

put a open pin in - for a vent just in case

[songdog]

bump

[Bossman]

put a open pin in - for a vent just in case

Yes if its a vial. 1ml is usually means sealed amps. Don't heat too much, they may blow.

[Focusmen]

Yes if its a vial. 1ml is usually means sealed amps. Don't heat too much, they may blow.

no theses are those miniture vials. there so cute! haha!:

[dieseljimmy]

my prop almost always looks like this. from my understanding it may in fact be slighly overdosed. I just draw into needle and run the syringe under some hot water for a minute and they disappear

[Focusmen]

I just boiled some water and put it in a coffee cut with the vial


after ten minutes looked clear as day

thanks for all the replies

[tubs]

Yes if its a vial. 1ml is usually means sealed amps. Don't heat too much, they may blow.

sorry didn't notice that.

glad it worked out

[Focusmen]

so i just got to some that have huge shards. like .25 inches long. hot water in cup dosent seem to work.

Ill try the boiling water meathod.

is ok to get them that hot? it doesnt change the moleculoar structure?

[ThatGuyYeahHim]

Im guessing it should be fine. Perhaps not ideal but what can you do.
Before you put it in boiling water, try this. Boil some water in a kettle. Get a shot glass, or cup and add boiling water. Let it COOL for a minute before inserting the vial and let it stand. Perhaps holding top of vial swirl it a little?

Just remember to let it cool down before you shoot it