What the hell is going on?!

[MrBucket22]

I home brewed 60ml of Test-E. I used 2%BA 15%BB and USP Unfiltered Cottonseed Oil. I Heated the oil to slightly over the melting point of Test-E (105F), added the powder, let the temperature drop slightly and added BB, than let it drop slightly more and added BA. The outcome was LIQUID GOLD!!

I have absolutely no pain during the injections. My first injection was in my left glute. The next day I had a large mass that was extremely painful as I couldn't lay on it, the next day slightly more painful but ultimately went away 4-5 days later. My second injection was my right quad, again no pain until the next day. In the morning it was so tight, and sore/tender to the point where I could barely get out of bed/walk. This went away 4-5 days later. I've done two more injections since, both behaved like the first two. In fact every single injection behaved this way (4 total).

3 Questions:

Could the solution be crashing in my muscle after injection causing extreme pain? If not what the hell is going on, this is defenitly not normal.

What can I do to fix this batch (if anything)? Would re-brewing a new batch be pointless?

Has anyone experienced this before?

Your insight will be much appreciated!

[cantbetouched]

My insight says .. this would be a great question in the recipe section sir. you will get many more educated replies there...

[MrBucket22]

I put it there too, but a lot more people view this section. But thanks!

[MACHINE5150]

I put it there too, but a lot more people view this section. But thanks!

i already posted in the other section.. this is a brewing question... i would say a good amount of the guys on this side of the forum dont know about brewing..

[Bonaparte]

Sounds like your brew is contaminated.

[MrBucket22]

Is there a way to un-contaminate? Should I try a new brew?

[Bonaparte]

Refilter and autoclave it.