cleaning gear.

[mockery]

ive used 4 ml out of a vial of way to high BA solution's. Prop doesnt hurt this bad. with 4ml gone is 0.5 add oil and bake it for 5 mins at 200 sound about right? i might try and get a fillter locally if i can.

any other suggestion , i am open to them. cheers

[>Good Luck<]

ive used 4 ml out of a vial of way to high BA solution's. Prop doesnt hurt this bad. with 4ml gone is 0.5 add oil and bake it for 5 mins at 200 sound about right? i might try and get a fillter locally if i can.

any other suggestion , i am open to them. cheers

Go to the lab section and repost. Also see ar-r for filters!

Good luck!

[measuretwicecutonce]

u mean cutting the gear? heat will do nothing u MUST run the oil thru a .2 or .22 (warm it to filter it easier, as well as use a low gauge). vent the vial with a needle open thru the rubber on one side and shoot the oil straight thru syringe filter into your vial. place vial on heat source. warm it for a bit, n then shake gently. gtg.

[mockery]

so its not as simple as add buffer oil, heat up to stile the new oil, mix and presto? gay!

thanks guys off to get some 22g filters!