Flakes won't disolve - Frag 176

**golarge** · 11-05-2009, 09:02 PM

I have a 5mg vile of Frag 176 I was going to use for my testing. Its been in BAC water and refrigerated for almost 24 hours now and thier are still a ton of visible flakes in it. Gently swirl it around every now and then, but the flakes never dissolve.

Any fixes, or is it likely a bad batch?

**The Deuce** · 11-05-2009, 10:30 PM

Sounds like some sort of FILLER to me...

**higherdesire** · 11-06-2009, 10:39 AM

Sometimes when i have stuff that wont dissolve rolling it back and forth in my hands slowly at an angle helps. Good luck

**tboney** · 11-06-2009, 10:41 AM

Originally Posted by golarge

I have a 5mg vile of Frag 176 I was going to use for my testing. Its been in BAC water and refrigerated for almost 24 hours now and thier are still a ton of visible flakes in it. Gently swirl it around every now and then, but the flakes never dissolve.

Any fixes, or is it likely a bad batch?

I wouldnt inject that! Send it back to your supplier and request a replacement.

**golarge** · 11-06-2009, 04:08 PM

Finally! 48 hours later the flakes are gone. Had to swirl it again for a good 10 minutes. Its a tiny bit cloudy, but that just because I haven't diluted it fully yet(only 3cc in 5mg).

I did contact the supplier and they're only response was "Cloudy is normal for frag."