My liquid clomid turned into gel.

**Anhydro78** · 11-22-2004, 07:44 PM

What is used in these research chemicals to as a solvent? I have a full bottle of research chemical CLomid that turned into gel. The lid was closed and was kept in the original container.

**AandF6969** · 11-22-2004, 08:00 PM

usually its grain alcohol, like everclear... i would think it would be the same concentration per mL wether its liquid or gel...

**dieseL atC** · 11-22-2004, 08:03 PM

Bring a pot of water to a boil and put the bottle in it until it's suspended in the solution..

**sober** · 11-22-2004, 08:12 PM

dieseL atC is right....just heat it again slowly. my homemade clomid is high mg/ml. and is a gel right now. i made sure its air tight and the lid is on good. when pct comes around, just warm up and draw out. easy as pie

**Anhydro78** · 11-22-2004, 09:40 PM

Add water or anything??

**AandF6969** · 11-22-2004, 10:11 PM

Originally Posted by Anhydro78

Add water or anything??

wouldnt that mess up the concentration

**Anhydro78** · 11-22-2004, 10:17 PM

I dont know what to add to it. I would think something has to be, since the stuff seem to have dried. It didnt taste anything like everclear.

**sober** · 11-22-2004, 10:43 PM

is it dried completely? it should've just turned into gel if it was grain alcohol used to dissolve. just try heating up in the container slowly, it should turn into liquid again. if it is infact alcohol, the vapors could escape completely drying it out i believe, make sure its air tight.