shots in that ass

[Nworb]

hehe coulda come out with mad funnier title, but

if i get the 23x1 3cc syri nges from ar-r
cani take the pi n of and replace it without hassle with the 23x 1.5 that they also sell
??????????

[Nworb]

come on somebody knows the answer
or pm with where 23x1.5s can be aquired

[pigrond]

yes you can

[Nworb]

is it just a simple snap off and snap on?? is there a filter that gets replaced???

[pigrond]

usually twist on no filter though i think you can get a filter

[Cat316]

its just like when you draw the gear...then you replace the needle...personally i use 1.5 for my ass but have used 1' also

[Selene]

hehe coulda come out with mad funnier title, but

if i get the 23x1 3cc syri nges from ar-r
cani take the pi n of and replace it without hassle with the 23x 1.5 that they also sell
??????????

yes you should have no problem doing so

[martinezega]

ya it should just twist off, but put the cap back on before you take it off, it makes it easier and safer.

[Decoder]

Yes.

[Nworb]

wait so when injectecting i draw it, throw the needle out put a new one on then inject???

[lex57]

come on somebody knows the answer
or pm with where 23x1.5s can be aquired

dude you only waited 4 minutes for a response from your original question........i dont get it

[dhriscerr]

wait so when injectecting i draw it, throw the needle out put a new one on then inject???

Step one, take 23g 1" needle, draw gear
Step two, Put cap on needle, pull plunger back a bit so gear is not in needle
Step three, Twist off 23g 1" needle
Step four, wipe bottom of new 23g 1.5" needle with alcohol pad where it screws in.
Step five, twist on new 23g 1.5" needle
Step six, remove cap
Step seven, Inject into site that has been wiped clean with alcohol pad and follow injection routine.


If you can't comprehend this broken down for you then you probably shouldn't be using AAS

[MikeCman]

personally, I wouldnt wipe the new pin top with alcohol bec. its already sterilized. just make sure when u take it out of the package the top doesnt touch anything and quickly put it right on the plunger. You might also end up getting alcohol into the pin and then you would be injecting rubbing alcohol into your body. The only things i rub with alcohol are the injection site and the top of the juice bottle. Let air dry too; dont blow on it.

[RA]

Make sure you put the new one on tight. I actually had one pop off mid shot.

[dhriscerr]

I didn't mean wipe the metal pin top, I said the bottom, the plastic blue colored part on the 23g or orange part on the 25g, just make one quick pass on the bottom incase you got anything on it before you screw it in, but go ahead and do it how you want, why not take extra saftey steps though?