Guys Help please!

[quaker48]

I'm having the worst time drawing oil into the syringe. Im following the detailed instructions on this board. Im using 23g to draw(it takes forever). Could this be the problem ? the bottles are 5ml. Would stitching to and 18g make a difference?

[chuckt12345]

should have no prb drawing with 23,, you shootin some air in the bottle then pulling back in fluid with the bottle upside down?

[quaker48]

should have no prb drawing with 23,, you shootin some air in the bottle then pulling back in fluid with the bottle upside down?

Yes doing all of that.

[chuckt12345]

what is the mg/ml

[chuckt12345]

shouldnt have problems unless the seal between rubber and needle is sukn air

[quaker48]

what is the mg/ml

250mg/5ml bottles

[quaker48]

I mean after like 30 tries I get it to work. maybe its me. It just seem like it shouldnt be that hard since im following all the steps.

[chuckt12345]

draw air,, shoot it in bottle, get in fluid and pull pluger back as far as it can go,, should pour right in,

[ghettoboyd]

if you can get 18 guage id do it...that what i use to draw and it is real easy.....than i use 23g to shoot......

[stpete]

Get 18's.....Those are the best to draw with.

[KimboHalfSlice]

I always draw with an 18 and then inject with a 23, works a charm.

[quaker48]

draw air,, shoot it in bottle, get in fluid and pull pluger back as far as it can go,, should pour right in,

okay so take plunger all the way back. should it be done fast or slow?

[chuckt12345]

wont matter if its in fluid,, just pull it back and hold it,, should flow in

[quaker48]

Thanks guys for all your advice.