Hitting depth with new squat suit

[endpoint]

Just got an ULTRA tight Titan Centurion super NXG+

Took me three or four goes before I got it on (with a lottttttttttt of help)....and its super tight.


I have been squatting just under 600 pounds raw.

But with the suit on I cant even get 660 down.

Should I just shove more weight on?

Should I wet the suit?

Should I just try and get deeper and deeper every week?

Any Ideas

[powerlifter18]

dont wet the suite. also remember to make sure the suite is up all the way and if u cant go paralell just add more weight untill u can

those suites are badass imagine a double ply

[artica]

sounds like the suit is right on....

master the suit, add little weight little by little, don't over do it TOO FAST.

Make sure you sit back hard and back then down, shove your knees out.

Just break it in, it typically takes about three sessions in the suit. Just be patient and don't move too fast with it.

Get some suit slippers.

[Doc.Sust]

work with the straps down, and you can use water all you want, once you start hitting depth, stop using the water

[pwrlftr2]

Okay, I've got a question and I apologise for my ignorance but once you get the suit or shirt broke in if you wash it is it going to tighten right back up on you or will it be broke in for good. I've got suits I train in that I wash in power wash and dry on a gentle cycle. They seem to retain their pop for ever. I have an old Inzer Hardcore that I have trained in and competed in over and over again and set new PBs all the time. I hear a lot of guys say they can only get so much out of their shirts and suits before they are stretched out. I have not found that to be the case. I have one of these new suits and I have the same issues breaking it in. Any thoughts are appreciated as I think we have the same problems.