Oil leaks in to syringe when injecting

[bsblltom]

I pinned today with a total of 3cc (1cc test, 1cc tren , 1cc EQ) and while I'm pushing in the syringe to inject the oil, the oil spills in to the syringe. I finish pushing all of the oil in and remove the needle and there is a decent amount of oil still in there, but it is above the plunger thing. If I tilt the syringe upside down the oil spills out. How do I prevent this from happening again? Am I injecting too quickly?

[fitnessNY]

It sounds like a bad seal on the plunger, the seal is not keeping the oil below it.

[David LoPan]

I also would say bed seal but if you have a 3 ML syringe and you put in more than 3 ml it can happen often. Might want to go to the 5 ml syringe.

[Clove1234]

Definite bad seal

[matri.x]

3cc is for horses! But change the syringe brand

[GearHeaded]

3cc is for horses! But change the syringe brand

3cc is definitely not for horses (actually male bodybuilders prob take in more AAS then horses do). 3cc is not a lot. lets say you were running 700mg test prop, 600mg tren a, 800 cc primo.. thats 21 cc per week just right there (with only 2g of gear). a 3cc syringe is a minimum for guys that run actual cycles and not just on TRT

[Ashop]

I pinned today with a total of 3cc (1cc test, 1cc tren, 1cc EQ) and while I'm pushing in the syringe to inject the oil, the oil spills in to the syringe. I finish pushing all of the oil in and remove the needle and there is a decent amount of oil still in there, but it is above the plunger thing. If I tilt the syringe upside down the oil spills out. How do I prevent this from happening again? Am I injecting too quickly?

Use a better brand syringe/pin combo,,,I like the B-D brand.